How much does radon mitigation cost in Colorado?

By RadonPages.com. Updated 2026-11-19. Facts on this page come from the government and legal sources listed at the bottom.

Short answer

Typical cost: about $1,000 to $3,000 for a system on an existing Colorado home, according to the state health department. In the state's low-income program, real jobs ranged from $495 to $5,800, averaging about $1,892. Houses with both a basement and a crawl space, several slabs or a finished basement usually cost more.

The Colorado Department of Public Health and Environment (CDPHE) gives two ranges. Its testing page says a system in Colorado usually costs about $1,000 to $2,000 unless the house has difficult design problems. Its radon FAQ puts a traditional system on an existing single-family home at about $1,300 to $3,000.

Data from the state's low-income assistance program shows the spread. In an April 2024 update, CDPHE reported 477 homes mitigated through the program since February 2018, at costs from $495 to $5,800 and an average of about $1,892. Those are real Colorado jobs, but they are one program's homes, not a survey of the whole market.

What are you paying for?

CDPHE describes sub-slab depressurization as usually the most effective method: a pipe and fan pull radon from under the floor and vent it outside. Homes with crawl spaces use sub-membrane depressurization, where a sealed plastic membrane covers the crawl space floor and the system draws air from beneath it. A house with both a basement and a crawl space, several slabs, or a finished basement that hides the slab tends to need more design work, which is where quotes above the typical range usually come from.

Cross-section of a house. A pipe runs from a suction pit under the basement slab up through the house to a fan in the attic and vents above the roof.123456
  1. Vent above the roof, so the gas spreads out outdoors.
  2. Fan in the attic or outside the house, not in the living space. It runs all the time.
  3. Pipe from the slab up through the house or along an outside wall.
  4. Gauge on the pipe shows that the fan is pulling air.
  5. Cracks and openings sealed, so the fan pulls from under the house.
  6. Suction pit under the slab, where soil gas with radon is drawn into the pipe.
Sub-slab depressurization, the most common method. Homes with a crawl space use a sealed plastic membrane over the dirt floor instead.

CDPHE also notes that caulking and sealing cracks is part of a mitigation job but is not a fix on its own, because sealing cannot close every crack and sealants dry out.

How do you compare quotes?

  • Ask which licensed professional will design and be responsible for the system, and check that person's license. Colorado licenses people, not companies. How to check.
  • Ask what radon level the contractor expects after the work and how it will be tested afterward.
  • Ask where the pipe and fan will go, and whether that affects your electrical work or permits in your town.
  • Get more than one quote. The spread in the state's own program data shows prices vary a lot from house to house.

Can you install a system yourself?

CDPHE says homeowners with good handyman and electrical wiring skills may be able to install sub-slab depressurization themselves. State law exempts only an owner working on the single-family home they own and live in. Mitigating any other home, paid or not, requires a state license (C.R.S. 12-165-106 and 12-165-107).

When is mitigation worth it?

The U.S. Environmental Protection Agency (EPA) advises fixing a home at 4 pCi/L or more and says to consider fixing between 2 and 4 pCi/L. CDPHE estimates radon causes about 500 lung cancer deaths a year in Colorado and that elevated levels are found in about one in two Colorado homes.

Low-income homeowners may qualify for state help. See LIRMA.

Prefer to browse? All Colorado radon mitigation companies, A to Z.